High Pressure Electric PCP Air Compressor 30MPa 4500PSI Scuba Diving Pump 110V

Description

Store category
Sign Up Now !
You may also like
High Pressure Electric PCP Air Compressor 30MPa 4500PSI Scuba Diving Pump 110V
Product Description
The oil-water filter is bigger and the filtering effect is better
Directly inflate the diving cylinder without air filter
Water-cooled submersible breathing high-peable diving cylinder, with activated carbon filter, pure output.
110V Electric PCP Air Compressor Diving Pump 30MPA
Specifications:
Voltage: 110-130v, 60Hz
Rated power:1.8kw
Motor speed: 2800r / min
Working noise: 70dB
Air output: 130L / min
Cooling mode: water cooling
Compression level: secondary compression
Lubrication method: splash type
Motor material: all copper coil
Cylinder head material: cast aluminum
Shell material: Steel
Pressure range: 0-40MPa
Working pressure: 0-30mpa (4500psi)
Maximum temperature: 80 ℃
Connector type: 8mm quick connect female
Package size: 49 * 28.5 * 43cm
Total weight: 20.5kgs
Note:
Oil: add piston type air compressor oil (the machine has no oil, because it is not allowed to carry oil by air)
Speed test: it takes 3 minutes for 0.5L oxygen cylinder to inflate 30MPa, 6 minutes for 1L oxygen cylinder to inflate 30MPa, and 40 minutes for 6.8L oxygen cylinder to inflate 30MPa.
Operation method of electric air pump:
1.Check the amount of oil before each use, the oil should exceed the red dot, but not too much. The Lubricating oil that is exported to foreign countries is taken out and needs to be added by itself.
2.Replace the breathing plug. Change the oil cover used for transportation to a strip-shaped breathing plug.
3.Loosen the air bleed screws on both sides before starting the machine(Remember, the machine needs to start under zero pressure. If the bleeder screw is not loosened, the machine will not start. After starting the machine, tighten the bleed screws on both sides to press normally After the end of the inflation, loosen the deflated screw and then deflate, then take the inflation joint).
4.To install the water pump, you need to put the water pump into the water. The more cold water, the better. After the water pump is normally circulated, the electric air pump can be turned on Manually shut down after reaching the required pressure,the whole process needs attention, and it is forbidden to leave.
5.The mechanical pressure gauge directly screws the pointer to the required pressure. When the pressure rises to the set pressure after starting, it will automatically stop.
6.Press the"SET"button to set the required pressure. Press"ON to start the machine. When the pressure rises to the set pressure,stop automatically.
Packing list:
1 x set of 30MPa high pressure air pump
1 x water pump
2 x water pipes
1 x filter
1 x spring hose
2 x pressure relief screws
1 x tank breather plug
1 x shock pad
1 x This manual
The oil-water filter is bigger and the filtering effect is better
Directly inflate the diving cylinder without air filter
Water-cooled submersible breathing high-peable diving cylinder, with activated carbon filter, pure output.
110V Electric PCP Air Compressor Diving Pump 30MPA
Specifications:
Voltage: 110-130v, 60Hz
Rated power:1.8kw
Motor speed: 2800r / min
Working noise: 70dB
Air output: 130L / min
Cooling mode: water cooling
Compression level: secondary compression
Lubrication method: splash type
Motor material: all copper coil
Cylinder head material: cast aluminum
Shell material: Steel
Pressure range: 0-40MPa
Working pressure: 0-30mpa (4500psi)
Maximum temperature: 80 ℃
Connector type: 8mm quick connect female
Package size: 49 * 28.5 * 43cm
Total weight: 20.5kgs
Note:
Oil: add piston type air compressor oil (the machine has no oil, because it is not allowed to carry oil by air)
Speed test: it takes 3 minutes for 0.5L oxygen cylinder to inflate 30MPa, 6 minutes for 1L oxygen cylinder to inflate 30MPa, and 40 minutes for 6.8L oxygen cylinder to inflate 30MPa.
Operation method of electric air pump:
1.Check the amount of oil before each use, the oil should exceed the red dot, but not too much. The oil that is exported to foreign countries is taken out and needs to be added by itself.
2.Replace the breathing plug. Change the oil cover used for transportation to a strip-shaped breathing plug.
3.Loosen the air bleed screws on both sides before starting the machine(Remember, the machine needs to start under zero pressure. If the bleeder screw is not loosened, the machine will not start. After starting the machine, tighten the bleed screws on both sides to press normally After the end of the inflation, loosen the deflated screw and then deflate, then take the inflation joint).
4.To install the water pump, you need to put the water pump into the water. The more cold water, the better. After the water pump is normally circulated, the electric air pump can be turned on Manually shut down after reaching the required pressure,the whole process needs attention, and it is forbidden to leave.
5.The mechanical pressure gauge directly screws the pointer to the required pressure. When the pressure rises to the set pressure after starting, it will automatically stop.
6.Press the"SET"button to set the required pressure. Press"ON to start the machine. When the pressure rises to the set pressure,stop automatically.
Packing list:
1 x set of 30MPa high pressure air pump
1 x water pump
2 x water pipes
1 x filter
1 x spring hose
2 x pressure relief screws
1 x tank breather plug
1 x shock pad
1 x This manual
Payment
Delivery details
Terms of sales
About us
Contact us
Payment
We accept PayPal payment only
Payment must be received within 7 days after order is made.
Fees such as import duties, taxes are not included in the item price or shipping costs. These charges are the buyer's responsibility.
Delivery details
Shipping:
The item will be shipped from our US warehouse to United States, which is more faster than from aboard.
2-9 working days to: USA
Terms of sales
We maintain high standards of excellence and strive for hundred percent customer satisfaction. Feedback is very important to us. We hope that you contact us immediately before you give neutral or negative feedback, so that we can address your concerns. It is impossible to address issues if we do not know about them!
About us
Your satis
faction is our ultimate goal. We work hard to earn your trust and future business. Our certified technicians have tested each item before shipping. The unit comes with 1 year limited warranty on all manufacturing defects.
a) If you receive a defective item, you may return it or ask for a discount. Please contact us within 14 days after you receive the package.
b) What you returned must be intact and in its original packaging as re? u. Customer is responsible for shipping costs of the returned item.
c) We will cover the cost of shipping back t with the shipping rate indicated in the registration page. We will send you a new unit or refund the full payment you paid.
Thank you.
Contact us
Business Hour
Business Hour: Monday To Friday: 8:30 AM to 5:00 PM (Beijing China time)
Due to time zones, our reply to your questions may not be immediately. But within above working time, we will reply your email within 24 hours. If it's non-workdays, please kindly be patient and wait till Monday.
Please contact us with ebay message.
Please feel free to contact us if you have any questions.
: Monday To Friday: 8:30 AM to 5:00 PM (Beijing China time)
Due to time zones, our reply to your questions may not be immediately. But within above working time, we will reply your email within 24 hours. If it's non-workdays, please kindly be patient and wait till Monday.
Please contact us with ebay message.
Please feel free to contact us if you have any questions.
Feedback
On May-18-21 at 01:27:10 PDT, seller added the following information: